Our shutters are custom built with the highest quality woods available. All of our exterior woods are clear, and without finger joints. Cedar is naturally decay resistant and straight.
Western Red Cedar, Spanish Cedar, Cypress, and Sapele Mahogany.
*Additional charges apply.Spray Primed*
Sprayed with top quality oil-based primer; light sanding recommended.
Primed and Sanded*
Sprayed with top quality oil-based primer, sanded and joints sealed; ready for finishing.
Primed and Finished*; Ready for Installation
Each shutter is sanded, primed with two coats of oil-based primer and sanded again. Then the primed shutters are finished with a premium exterior paint. Custom color charge may be applied to orders less than 60 square feet.
* Color finishes by Sherwin Williams, Benjamin Moore, and PPG may be matched by supplying the manufacturer's brand name, color number and color name. Anything else can be matched by swatch.
Exterior Louvered Shutters manufactured by Southern Shutter can be customized to meet most customers specifications. Some common applications are shown below. Other options are illustrated on the following pages. For additional options call 1-800-344-8590 or visit our website www.southernshutter.com.
Recessed Stile & Rail Shutter
Recessed Stile & Rail Shutter
Recessed Stile & Rail Shutter
2 Section Recessed Stile & Rail Movable Louver with Quarter Arch Top
2 Section Recessed Stile & Rail Movable Louver over Raised Panel Shutter
2 Section Recessed Stile & Rail Movable Louver Shutter with Solid Arch Top
2 Section Recessed Stile & Rail Movable Louver Shutter with Rail Placement
2 Sections with Rail Placement
2 Equal Sections with Solid Arch Top
Rail Placement with Small Top and Bottom Sections
2 Equal Sections with Quarter Round Arch Top
2 Equal Sections with Rake Top
2 Equal Sections with Rake Bottom
2 Equal Sections with Modified Wide Side Stiles
Combination Movable Louver over Raised Panel with 2 Equal Sections
3 Equal Sections with Horns
2 Equal Sections with Eyebrow Arch Top
2 Equal Sections with Copper Cap
Rail Placement with 3 Sections and Small Transom Top
It is important to measure your shutter pocket at the top and the bottom and on both sides, because window frames may not always be square.
Remember to measure and re-measure to verify your numbers before selecting your shutters and the desired mounting proceedure.
Southern Shutter Company offers a complete line of quality hardware for any exterior application.
Our hardware provides the finishintg touch for your functional - as well as decorative shutter installation.
with wood or composite trim with appropriate depth for shutter pocket. Note: Trim board must be as thick as the shutter, plus clearance for shutter rotation.
with appropriate depth for shutter pocket. Note: Strap and Pintel are equal allowing shutter to close flush.
Allowing for closure inside window trim and throwing out and around structure.
with little or no depth for shutter pocket.
